I press my printed fabric page onto a piece of HeatNBond cut to the same size as my page. At this point, I thought that I had the whole iron on label thing covered, but my finished labels were a bit see through with the fabric print on my thread catchers showing through the label. I wanted something less transparent. After removing the paper backing from the HeatNBond, I pressed it to a sheet of white printer paper. So again, I have a great label, it has a nice crisp feel to it, the fabric does not show through, but it has a paper backing. It's back to the HeatNBond for one last layer pressed onto the back of the paper.
One more time, in a nutshell. I have the printed fabric paper as the first layer. Remove it's paper backing and press onto a sheet of HeatNBond. Remove the paper backing from the HeatNBond and press to a sheet of white printer paper. Press the printer paper to another sheet of HeatNBond and your label sheet is complete.
The next step is to cut the labels. I draw lines between the columns with a heat sensitive Frixion pen.
Then cut the labels into horizontal strips using the rotary cutter.
I like to use my 3mm scalloped pinking shears to get the cute little scalloped edge for my labels. Yes, I could just cut them straight with regular scissors, but these look so much CUTER! Lightly press with the iron if any of the Frixion marks remain after cutting.
Press these fabric labels onto your product and when I say press... I mean PRESS! Do not move the iron back and forth. If you do, the layers of the label may separate with the heat being applied. Give it a really good pressing, then let the label cool.
I hope that you have enjoyed this little tutorial. Again, these labels will not work for everyone or for every product, but they are the perfect branding solution for Curry Bungalow!
UPDATE - Since posting this tutorial, I have done some experimentation to see if my labels are indeed colorfast. I laundered a label and was pleased to see that there was absolutely no fading of the printer ink. None at all! But... and there is always a "but", isn't there? The paper backing that I ironed on to make the label more opaque did not fare so well. This issue would be easily corrected by adding another layer of the fabric printer sheets rather than the card stock.
And because I can never just leave anything alone... I have begun stitching around my labels before I iron them onto my product to give the appearance that they are actually sewn on. That's just another little touch to make a better and more professional looking finished product.